Vortex Silver Series Manual do Utilizador descarregar pdf (Página 13)

VORTEX

SILVER SERIES

Z ≥ 2*Z

min

Bottom SPEAKON

Upper SPEAKON

Input

Channel A

Input

Channel B

USER MANUAL

VORTEX SILVER SERIES V8

P.12

3.3.4 Mono Bridge Operation

One-channel mono bridged operation.

The second channel processes the same input signal, but with reversed

phase. The (single) load is connected between the two positive channel

outputs using a suitable connected SPEAKON connector. While the total

output of the amplifier remains the same,both the available output voltage

and the minimum impedance that can be connected are doubled - like

being operated in dual channel operation. Only channel A-Input is active

– turn the volume on channel B down to zero.

WARNING: In Mono Bridge Operation RMS output voltages are as

high as 260 V. Wiring to the speaker loads must conform to NEC Class

3 safety standards or its equivalent that meets all national and local

electric codes. All customer specific cables may only be manufac-

tured by qualified suppliers/personnel. All cabling or rewiring work

must be carried out by qualified personnel.

*Zmin= 2 Ω for V8

3.3.5 SPEAKON Connection

Both SPEAKON connectors are connected to channel A and channel B

outputs. The pin configuration of the SPEAKON connectors is as follows:

Upper SPEAKON: Pin 1+ Channel A signal

Pin 1- Channel A ground

Pin 2+ Channel B signal

Pin 2- Channel B ground

Bottom SPEAKON: Pin 1+ Channel B signal

Pin 1- Channel B ground

Pin 2+ Channel A signal

Pin 2- Channel A ground

3 INSTALLATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Sem comentários

Vortex Silver Series Manual do Utilizador Página 13