VORTEX
SILVER SERIES
USER MANUAL
VORTEX SILVER SERIES V8
P.16
4.3 Indicators
Input Selection LED
Output Mode LED
Clip LED Channel A
Signal LED Channel A
Device Identifier LED
Clip LED Channel B
Signal LED Channel B
DSP LED
U
man
LED
4.3.1 Input Selection LED
The status of the bi-coloured (green/red) LED changes between off, green,
and red depending on the selected Input Selection (see 4.5.1).
LED is off - Analog Inputs active
LED lit green - Digital (U
man
) inputs active
LED lit red - If Digital with Analog Fallback is selected, the red
Input Mode LED indicates that one of the digital
inputs have failed and will be replaced by analog
backup signal.
4.3.2 Output Mode LED
The status of the bi-coloured (green/orange) LED changes between off,
green, and orange depending on the selected Output Mode (see 3.3 &
4.5.2).
LED is off - Dual Channel Operation
LED lit green - Mono Bridge Operation
LED lit orange - Parallel Mono Operation
4.3.3 Clip LED (Channel A/Channel B)
This LED indicates an overloading of the amplifier when the power output
level is too high.
4.3.4 Signal LED (Channel A/Channel B)
The green Signal LED is illuminated when the voltage level at the output
reaches approx. 4 V; this corresponds to a power of approx. 4 W over a
4 Ω resistor.
4.3.5 Device Identifier LED
This white coloured LED helps you to identify an amplifier in a large U
man
network. By activating the Identify Device function in U
man
software, the
Device Identifer LED of the corresponding amplifier will shine.
4.3.6 DSP LED
The green DSP LED is illuminated when the optional DSP-Board (see
www.camcoaudio.com for more information) is installed and routed into
the signal path.
4.3.7 U
man
LED
The green U
man
LED is illuminated when the amplifier is connected to a
U
man
network.
4 OPERATION
Comentários a estes Manuais